The main cause of the motor failure has been widely attributed to the propeller’s vibration which over time causes the motor’s bond to the CF Arm to come apart, or to cause the rotation of the engine, with subsequent catastrophic failures.
The patent pending solution has been 100% designed and engineered by Atellani in Italy. Parts are made in: Germany, Italy and China.
Watch the video.
Not compatible with DJI's Inspire 2 Propeller Guard.
1x LEFT ROD
1x RIGHT ROD
2x CLAMP A
2x CLAMP B
2x COLLAR B
2x COLLAR S
2x ADHESIVE B
2x ADHESIVE S
1x HEX KEY
PLEASE NOTE: THE MOUNTING PROCEDURES HAVE TO BE MADE IN LANDING MODE. THE RIGHT AND THE LEFT ROD HAVE DIFFERENT MOUNTING PROCEDURES.
LEFT ROD MOUNTING INSTRUCTIONS:
Start mounting the left kit, by facing the left side of the drone. The mounting procedures have to be made in landing mode.
First place Clamp A around the landing gear and insert the Left Rod into the hole. Repeat the procedure on the other side placing Clamp B and screwing the Left Rod clockwise.
Use the Tightener to turn the Spring Pin clockwise until the Left Rod is completely firm and the Pin is in upright position.
Use a coin or any other sturdy tool to push the Spring Pin up until it sticks out rom above the Rod only.
Place the adhesive strips on the inside of Collar B and Collar S.
Place Collar S behind the drone’s arm and the Left Rod. Make sure the Spring Pin is placed in the middle of the Collar.
Align the upper parts of Collar B and Collar S. Snap them into place, ensuring all parts are completely secured and enclosed.
Tighten both screws with the Hex Key to secure the Collars. Be careful not to deform the plastic components.
RIGHT ROD: Please note that the Right Rod follows the same procedure as the left, but the rod needs to be screwed counter clockwise.
RIGHT ROD MOUNTING INSTRUCTIONS:
ATTENTION: TO FIT THE RIGHT ROD FOLLOW THE SAME PROCEDURE AS THE LEFT ROD, BUT SCREW THE RIGHT ROD COUNTER CLOCKWISE.
If you wish to print the Quickstart guideDownload here